Bird Feeder
For block seed
Tools needed:
Table saw or skill saw or gig saw, hammer, screw driver, drill and creset wrench.
A. 3 inch eye bolt with nut and washer.
B. 1 by 5 inch by 5 inch top.
C. 1 by 10 inch by 10 inch top.
D. 1/2 inch by 1/2 inch by 9 inch side peace's.
E. (quanity4) 10 1/2 inch bolts with nuts and washers.
F. 1 by 10 inch by 10 inch bottom.
G. (quanity 2) 8 inch by 6 inch clear plastic.
H. 4 1 1/2 wood screws for mounting sides to top.
I. 4 1 1/2 wood screws for mounting top plates together.
Fist connect B and C with the screws from I, then drill holes 1/2 inch in from cornners of C and F for bolts.
Then mount D to C one inch from cornners of C with the wood screws from I, then drill hole threw the
center of B and C and mount the eye bolt from A. Drill 4 holes 1/4 inch in from the cornners of G the plastic
sheld and mount in the center of D front and back with 1/2 inch wood screws, Then mount stucture together
useing bolts and nuts and washers from E.