Bird Feeder

Tools needed:

Table saw or skill saw or gig saw, hammer, screw driver, drill and creset wrench. 

A.Eye bolt 2 inch with nut and bolt.

B.Roof  1 by 6 inch by 10 inch (quanity) 2

C.Sides (quanity) 2 see diagram below.

D.Bottom front and back edge 1 by 2 inch by 10 inch (quanity) 2

E.Bottom side edge 1 by 2 inch by 6 inch (quanity) 2

F.4 inch by 7 inch plastic with  4 (1/2 inch) screws each (quanity) 2

G.Bottom 1/4 inch by 6 inch by 10 inch

H.Two hinges 1 inch with screws

Starte with E,D,G use finishing nails to put them together, then use 4, 1 inch wood screws to

mount the two sides C in the center of the bottom G, 6 1/2 inches apart.

Then take F. the two peaces of plastic, clear or colored drill for holes a 1/4 of an inch from

the sides (see drawing) . Then screw into the sides of C. Leaveing a one inch gap at the bottom

for an opening for the seed to come out. Then mount B. the roof useing 4 1 inch wood screws

to the left side of the roof only, then mount the hinges to the left side of the roof. Then slide

the right side of the roof into place and screw the hinges into it. This will alow you to lift the

right side for filling with seed. Then A. the eye bolt should be put in the left side of the roof

so the right side can open. Use the eye bolt only if you plan to hang the feeder.

                Back                                                     Home