Hope Chest
Tools needed:
Table saw or skill saw or gig saw, hammer, screw driver, drill and creset wrench.
Parts:Use Mahagony wood
(Quanity 10) (2 inch L ) brackets
(Quanity 8), 1 1/2inch wood screws
(Quanity 2), 3 inch slide hengs
A.Top 18 inchs x 36 inchs
B.Front and back 18 inchs x 36 inchs
C.Bottom 20 inchs x 38 inchs
D.Front and back legs 3 inchs x 36 inchs (see diagram below)
E.Sides 17 inchs x 18 inchs
F.Side legs 3 inchs x 17 inchs
Directions: Useing the 8 wood screws mount the legs to the bottom of the bottom peace, then use the (L)
brackets to put the sides and front and back together, Then useing the last of the (L) brackets mount to
bottom. Then install hengs to the top and fram, Sand and lacker .