Drawing and Painting Easel
Tools needed:
Table saw or skill saw or gig saw, hammer, screw driver, drill and
creset wrench.
Wood and parts needed below.
A.1inch x 3inch x 5 feet pine.( Quanity 4)
B.1/2inch x 28inch x 36inch chip board.
C.1/4inch x 36inch clear plastic brase for paper.
D.(quanity 2) 1foot folding hing
E. (side 1 and 2) 1inch x 2inch x 7inch, (front) 1inch x 2inch x 29inch, (bottom) 1inch x 4inch x 29inch
refer to drawing below.
F.(quanity 2 of everything)1 1/2 inch bolt 3inches long with 3 washers and nut.
G.(quanity 22 ) 1 1/2 inch wood screws
Round the tops and bottom ofthe legs useing a jig saw, Then drill holes for bolts at the top of the legs.
Useing eight wood screws mount (B) to two of (A) front legs, then mount (E) to the base of (B) to the
side of (A) useing 4 wood screws, then mount the two hinges to the front legs, then bolt the legs together.
Then screw the plastic holdind brase (C) to (B).