Bird House 3
Tools needed:
Table saw or skill saw or gig saw, hammer, screw driver, drill and creset wrench.
A. Left side roof 1 by 4 1/2 inch by 7 inch, right side 1 by 4 inch by 7 inch.
B. (quanity 2) refer to diagam below.
C. Front and back 1 by 6 inch by 6 inch.
D. (quanity 2) sides 1 by 6 inch by 7 inch.
E. Bottom 1 by 6 inch by 10 inch.
F. Bottom mounting peace 1 by 6 inch by 6 inch.
G. post 4 by 4
H. (Refer to picture) 2 inch entry hole.
I. (quanity 2) 2 inch henges
J. Wood screws (quanity 24) 1 1/2 inch.
Screw together b,c,d, then bottom e, then left side a, then henges I, then screw hinges to right side a.
This will allow you to lift up the right side for cleaning. Then screw together mounting plate f to e then
mount to g the post.