Bird House 2
Tools needed:
Table saw or skill saw or gig saw, hammer, screw driver, drill and creset wrench.
A. Right top 1 by 7inch by 10 inch, left top 1 by 6 1/2 inch by 10 inch.
B. Front and back (see diagram below).
C. (quanity 16) 1/2 inch by 1/2 inch by 10 inch.
D. (quanity 12) 1/2 inch by 1/2 inch by 8 inch.
E. Bottom 1 by 10 inch by 10 inch.
F. 4 by 4 post.
G. Mounting plate.
H. (quanity 2) 2 inch henges.
I. Mounting bolts (quanity 2) 6 1/2 inch bolts with nuts and washers.
J. Mounting bolts (quanity 2) 4 1/2 inch bolts with nuts and washers.
K. (quanty 4) 1 1/2 inch wood screws.
L. Cut hole for bird entry way (see picture).
First glue peaces (C) and (D) formming the center of the house, let dry. then drill holes for mounting bolts threw
all 4 walls and (B) and (F) peace's, then bolt peaces together (refer to picture). Next useing wood screws (K)
screw left side roof (A) to top, then mount henges (H) to top of roof left side, then slide right side roof (A)
under henges and screw in. This will allow you to lift right side for cleaning. Then mount bottom plate on
bottom of bird house, then mount to pole.