Bird House 1
Tools needed:
Table saw or skill saw or gig saw, hammer, screw driver, drill and creset wrench.
A. Back mounting plate 1 by 4 by 8 inch wood with two 1 1/2 inch wood screws.
B. Left side top 1 by 10 inch by 1 foot.
C. Right side 1 by 9 1/2 inch by 1 foot.
D. Front and back peace, Cut out of two 1 by 10 inch by 16 inch boards.
E. Right and left side 1 by 6 inch by 1 foot.
F. Bottom 1 by 1 foot by 1 foot 3 inches.
G. Wood or asphalt shingals.
H. One 2 inch flat henge with screws.
On center peace (D) front, cut a round hole diameter 2 inches, 2 inches from bottom center
for bird entry way.
On center peace (D) back cut out a 3 inch by 4 inch peace 2 inches from bottom center, use
3 inch by 4 inch peace with flat henge (H) to reconect to back center peace for clean out.
Useing (quanity 14) wood screws 1 1/2 inches long mount center peace (D)front and back to the bottom peace (F) one foot apart leaveing a pearch infront, then mount right and left sides (E) to the center peaces,then right and left tops (A) and (B) to the center peace, then on back mount the mounting plate (A) just above clean out. Then add (G).
Then paint or stain your bird house.